1.              Development - in Ansco 130 1:2 for 2.5 minutes.

2.               Stop Bath - Running plain water (no-acid)

3.               1st Fixing Bath - Fix in a fresh non-hardening alkaline rapid fixer TF-3 at 1:4 dilution for 60 seconds.

4.               Hold Water - Hold in water till the end of the printing session but not more than 2 hours in the winter and 1 hour in the summer when the water temperature is warmer. Change the water from time to time, replenish with running water.

5.               2nd Fixing Bath - Fix in a fresh non-hardening alkaline rapid fixer TF-3 at 1:4 dilution for 60 seconds including draining.

6.               Selenium Toner - Prints go from the 2nd fixer directly to the selenium toner tray. I tone all prints in Kodak Rapid Selenium Toner for archival processing and pleasing print tone. Times vary, but with warmtone papers I usually use a dilution of 1:19 and tone for 4 minutes.

7.               Water Tray - Water rinse for one minute.

8.               Hypo Clearing - Soak in a fresh hypo clearing agent (HCA) solution for 3-5 minutes with agitation.

9.               Water Tray - Rinse for 2-3 minutes in running water. Changing and replenishing the water constantly.

10.           Archival Wash - First wash for 30 minutes in an archival print washer.

11.           Hypo Clearing - Soak in a fresh hypo clearing agent (HCA) solution for 3-5 minutes with agitation.

12.           Water Tray - Rinse for 2-3 minutes in running water. Changing and replenishing the water constantly.

13.           Archival Wash - Final wash for 30 minutes in an archival print washer.

14.    Distilled Water Tray – I put 2-3 drops of Photo Flo in distilled water and agitate the prints rigurously for 30-60 seconds.

15.           Squegee the prints on both sides, air dry face down on clean fiberglass screens.

16.          I flatten the prints in a dry mounting press and trim to final size.

17.           I dry mount on 100% cotton museum board.